Press start says jam in the center with jam code e21. No bells or whistles no motor movements or solenoids or fingers moving just goes to jam when start is pressed. Machine will clear deck way to should when button to do so is pressed. "Manual says Material
never released
from the
transport plate"
I've cleaned checked all sensors and in service mode. Took transport sensor to another machine an it works. Replaced main Board same problem in same machine...so not sensor or board. But....op5 sensor works opposite of the way it should in service mode an via meter readings an that other machines test same sensor. Talked to Tech suport an they are at a loss. Pics of details.
never released
from the
transport plate"
I've cleaned checked all sensors and in service mode. Took transport sensor to another machine an it works. Replaced main Board same problem in same machine...so not sensor or board. But....op5 sensor works opposite of the way it should in service mode an via meter readings an that other machines test same sensor. Talked to Tech suport an they are at a loss. Pics of details.
Comment