Canon ir-advc 5035i

[mramlawi]

dear all ,

i have canon ir-adv5035i theirs a mismatch in lines ,i enter the maintenance and tried to make mismatch correction but the machine gave me it theirs something wrong try again or call service is theirs any way to solve this ,i changed the belt assembly and same problem .

[zoraldinho]

Re: Canon ir-advc 5035i

1. service mode level 2: Copier > Function > Clear > REG-CLR
2.Check shutter on the patch reader
3.Clean the registration sensors
4.do a auto color mismatch adjustment again
5. Check COPIER>ADJUST>IMG-REG value If value 0 enter the values from the front door label and do a auto color mismatch adjustment again

[mramlawi]

Re: Canon ir-advc 5035i

1. service mode level 2: Copier > Function > Clear > REG-CLR
2.Check shutter on the patch reader
3.Clean the registration sensors
4.do a auto color mismatch adjustment again
5. Check COPIER>ADJUST>IMG-REG value If value 0 enter the values from the front door label and do a auto color mismatch adjustment again

thanks for ur response ill try it and reply

[mramlawi]

Re: Canon ir-advc 5035i

Hi yea the values was 0 i put the value"s lable ,but same massage appeard , where "s the patch sensor location ? I chcked everything on the the belt .

[teckat]

Re: Canon ir-advc 5035i

Hi yea the values was 0 i put the value"s lable ,but same massage appeard , where "s the patch sensor location ? I chcked everything on the the belt .

--COPIER > ADJUST > FEED-ADJ > REG-SPD:

The default is 0 and the range is -5 to +5.
try a - adj

//on a Cross Feed (Operator to Non-Operator Side) issue ???
>>make sure the lens that cover the registration sensors are not scratched > throws of readings> causing a misread of the registration patches on the ITB Belt.


? Performed a REG CLR in service mode level 2: Copier > Function > Clear > REG-CLR


what direction is the issue ?

DIRECTION.jpgor both ways/ check COPIER > TEST > PG 6 grid pattern test print




also check your PG10 PRINT
pg10.JPG

[Tricky]

Re: Canon ir-advc 5035i

If its in paper feed direction........ print a pg6 as Techkat suggested

service mode level 2

LD-ADJ-(Color you have problem) with Return Y Skew Crrct Motor to ini pstn
Lv.2 Details When Y-color skew volume in vertical scanning direction is larger
than estimation, the Image Skew Correction Motor (Y) is locked,
and color displacement cannot be corrected even when color
displacement correction control is executed. This item places the
Image Skew Correction Motor (Y) to the center position in such
cases.
Use case When replacing the Laser Scanner Unit to identify the failure position
Adj/set/operate method Select the item, and then press OK key.
Caution After opening and closing the door during operation, execute the
service mode again even if “OK!” is displayed.
Display/adj/set range During operation: ACTIVE, When operation finished normally: OK!
Required time 10 sec

[mramlawi]

Re: Canon ir-advc 5035i

Thank you my problem is solved after i cleaned the led sensor located beside the registration sensor also after i turned back the adjt values from the front door and making clear reg then laser adjt and it works thanks alot