[Error Code] E532

[wassem]

hi everybody

i have E532-8001 in saddle finisher v2 of the machine ir 7105

i think this error is related to the movement of the stapler

i think the the photos and the motor are working

may the problem in the rail of movement , i lubricated it but no luck

anyone has new idea,i will appreciate

thanks in advance

[wassem]

Re: E532

hi everybody

i have E532-8001 in saddle finisher v2 of the machine ir 7105

i think this error is related to the movement of the stapler

i think the the photos and the motor are working

may the problem in the rail of movement , i lubricated it but no luck

anyone has new idea,i will appreciate

thanks in advance

can i use the function limited to stop the stapler only

means stop stapler and use offset collating in the same time

[teckat]

Re: E532

can i use the function limited to stop the stapler only

means stop stapler and use offset collating in the same time

================================================== =========================
e-532-8001 - stapler shift motor fault
- stapler HP sensor fault
- finisher controller PCB fault
The stapler HP sensor does not go off within 500 msec after the start-up of the stapler shift motor.
- Check the connectors of the stapler shift motor.
- Replace the stapler shift motor.
- Check the connectors of the stapler HP sensor.
- Replace the stapler HP sensor.
- Replace the finisher controller PCB.





Limited Functions Mode
* is default off

Finisher Tray A/B: ON/ OFF*1
Finisher Saddle Stitcher Unit: ON/ OFF*1
Finisher Inserter: ON/ OFF*1
Folding Unit: ON/ OFF*1
Puncher Unit: ON/ OFF*1
Stacker: ON/ OFF*1





make sure your finisher door latch is secure
Confirm the screws for the magnet that holds the door in place are tight and the door is closing properly.

an interruption of 24v during finisher use can cause e532

V2
On the Fuse Box PCB, check pins 1, 2, and 3 on J418 and pin 1 on J416 for 24 volts. If there is no voltage present, press and hold the reset button on the bottom of the Relay on the Fuse Box PCB. If you then get 24 volts on J418 and J416 while holding the button, check the harness on J413 for continuity across pins 2 and 3. There must be continuity across the two pins or the Relay turns off the 24 volts to the stapler. If you are getting not continuity at that harness, check MSW5 and MSW6.

[aco.bk]

Re: E532

ir7105 V2.jpgCheck attached image.if gear 14 turns around axle error e532-8001 will appear.