pg test magenta misalign

[q555]

hi everyone,

sorry for the last 2 post. it views as printable because i put "print" in the title.

pg test print magenta misalign.

is this magenta laser problem?

Model: IR-ADV C5045

thanks.

[mramlawi]

Re: pg test magenta misalign

did u make mis match adjust ,and then auto graduation , must work with you

[Rachid.Akli]

Re: pg test magenta misalign

hi everyone,

sorry for the last 2 post. it views as printable because i put "print" in the title.

pg test print magenta misalign.

is this magenta laser problem?

Model: IR-ADV C5045

thanks.

Hi to evry one, I am back again.

For misalignement issues, it is better to print PG-TYPE 6.
Clean the patch sensors (Front/Center/Rear) (UN47 / UN48 / UN49) located under the ITB in the right side of the machine.

Rachid.

[q555]

Re: pg test magenta misalign

thanks for the reply rachid.

i tried to test the AT-IMG-X and the result is NG!

do i need to replace the patch censors? will this correct the magenta misalignment?

[Tricky]

Re: pg test magenta misalign

First check the patch sensor shutter fc8-4540 is not broken.

Try this

sevice mode level2 copier > function > laser

LD-ADJ-M Restore M Skew Crrct Motor initial pstn
Lv.2 Details When M-color skew volume in vertical scanning direction is larger
than estimation, the Image Skew Correction Motor (M) is locked,
and color displacement cannot be corrected even when color
displacement correction control is executed. This item places the
Image Skew Correction Motor (M) to the center position in such
cases.
Use case When replacing the Laser Scanner Unit to identify the failure positio
Adj/set/operate method Select the item, and then press OK key.
Caution After opening and closing the door during operation, execute the
service mode again even if “OK!” is displayed.
Display/adj/set range During operation: ACTIVE, When operation finished normally: OK!
Required time 10 second

[ss12]

Re: pg test magenta misalign

Also check the led for the cleaning lamps.Had one pop out of position and this caused a misalignment in the colours