[Error Code] iRA9070 - Multiple Error E007/E074/E013

[Ramanan]

Hi

we are getting multiple errors in iRA9070 printer. The First one is E007-0101 Replaced new Fixing Belt assy and Shift control assy still the problem is same.

when we powered the machine on with front door open Error : E074-001 and E013-003 errors occuring.

Replace new Fixing upper belt assy/fixing feed driver pcb and shift control motor assy for upper fixing belt.

Kindly share if any one faced the problem.

Regards,
Ramanan.

[teckat]

Re: iRA9070 - Multiple Error E007/E074/E013

E013
To enable the "Waste Toner Message", set Service mode COPIER > OPTION > DSPLY-SW > WT-WARN from the default value "0" (which will disable the message) to "1" (which will enable the message).
;-)
NOTE: The waste toner should be emptied on every service call.

E007
Check for scraps of paper in the fuser connector.

1.COPIER > FUNCTION > CLEAR > FX-L-CLR

2. COPIER > COUNTER > DRBL-1 > FX-BLT-U

3. COPIER > COUNTER > FIXING > FX-BLT-U

After clearing the counters please excecute the belt displacement control in service mode Level 1 again under COPIER > FUNCTION > FIXING > FX-UHP.

[vigour]

Re: iRA9070 - Multiple Error E007/E074/E013

What voltage are you running that machine on. It should be 208volts
The specs are written on the plug
The C9065 and C9075 require 208VAC from a NEMA 6-15P outlet.

Also check your lower fixing lamp. It should be 208v also
Some one might have put a 7055 lamp or fixing assemply in your 9070

These will cause multiple Ecodes

[Ramanan]

Re: iRA9070 - Multiple Error E007/E074/E013

What voltage are you running that machine on. It should be 208volts
The specs are written on the plug
The C9065 and C9075 require 208VAC from a NEMA 6-15P outlet.

Also check your lower fixing lamp. It should be 208v also
Some one might have put a 7055 lamp or fixing assemply in your 9070

These will cause multiple Ecodes

Hi All,
Problem resolved after Power supply repaired and fixed.

Thank You.
Ramanan