problem IP 7000 VP

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Joseph2011
    Technician

    50+ Posts
    • Aug 2011
    • 88
    #1

    problem IP 7000 VP

    good night
    I have a question about an IP VPN 7000 is too magenta toner falls into the development unit and constantly get the code E020-0286
    ATR sensosr clean and still working normally but consuming too much magenta toner and sprinkled throughout the magenta process unit someone who can help me some value you need to change to not consume too much toner or some adjustment within the team
    Thank you
    Tags: None
    • teckat
      Field Supervisor

      Site Contributor
      10,000+ Posts
      • Jan 2010
      • 16083
      #2
      Re: problem IP 7000 VP

      Check M DRUM seals\ they leak toner


      1) Clean the Drum Patch Sensor and the 1) Clean the Drum Patch Sensor and the surrounding areas.
      2) Enter Service Mode; COPIER>ADJUST>DENS>P-TG-x (LVL 2).
      Add a value of +10 to the color which is having the toner dropping issue.(Default Values: Y-10, M:+6, C:+20, K:+6).
      Example: If the Magenta is having the problem P-TG-M should be changed from +6 to +16.
      Replace the Starter, and perform a Full Auton Gradation.surrounding areas.
      2) Enter Service Mode; COPIER>ADJUST>DENS>P-TG-x (LVL 2).
      Add a value of +10 to the color which is having the toner dropping issue.(Default Values: Y-10, M:+6, C:+20, K:+6).
      Example: If the Magenta is having the problem P-TG-M should be changed from +6 to +16.
      Replace the Starter, and perform a Full Auton Gradation.
      **Knowledge is time consuming, exhausting and costly for a trained Tech.**

        Comment

        • Joseph2011
          Technician

          50+ Posts
          • Aug 2011
          • 88
          #3
          Re: problem IP 7000 VP

          Originally posted by teckat
          Check M DRUM seals\ they leak toner


          1) Clean the Drum Patch Sensor and the 1) Clean the Drum Patch Sensor and the surrounding areas.
          2) Enter Service Mode; COPIER>ADJUST>DENS>P-TG-x (LVL 2).
          Add a value of +10 to the color which is having the toner dropping issue.(Default Values: Y-10, M:+6, C:+20, K:+6).
          Example: If the Magenta is having the problem P-TG-M should be changed from +6 to +16.
          Replace the Starter, and perform a Full Auton Gradation.surrounding areas.
          2) Enter Service Mode; COPIER>ADJUST>DENS>P-TG-x (LVL 2).
          Add a value of +10 to the color which is having the toner dropping issue.(Default Values: Y-10, M:+6, C:+20, K:+6).
          Example: If the Magenta is having the problem P-TG-M should be changed from +6 to +16.
          Replace the Starter, and perform a Full Auton Gradation.

          thank you very much'll apply what we are putting me in touch

            Comment

            Previous template Next
            Working...