IR8500 finisher

[pudgi300]

Hi
Have 8500 finisher with 1129 jam code . I have replaced belt and gear tension unit in front of punch waste container. Only get it when going to second tray . Could one of the solnoids be causing this. Thanks for any hints on this jam code. I don't has access to database.


Later Pudgi

[BLITZKREAGG]

ir 8500

This is what I found
Problem :

1129 Jam Code


Solution :

It has been found that bushings FS5-6657-000, item number 9, and XG9-0362-000, item number 11, on the Sort Guide Assembly can become worn or dirty resulting in 1129 jam codes. Clean or replace as necessary.

Problem :
Jam code 1129

Solution :
Stationary jam at lower path sensor S3. It has been found that a shaft and bearing wear out. The shaft is located next to item 79, bearing, on page Q30-3. The part number for the shaft is FB5-9090-000 and the bearing is XG9-0403-000.

Hope this helps at all.

[OtherTech]

Take a good look at the sensor right after the paper goes down from upper path. Had one where the actuator was catching on the guide plate.

[pudgi300]

Thanks for the tip. They have been running 11x17 paper all day so have to wait for 8 1/2 x 11 job. I have replaced the sort swing assmy ( fg6-7500-000 ). Will check the sensor and bushing in the sort area. Had one of the bushings go bad and make a lot of noise but did not jam. Will get back with what i find.

Thanks Again
Pudgi

[pudgi300]

Hi,
Got a chance to work on the 1129 again and found that the shaft that drives the knurled belts was the problem. The rear bearing retainer for shaft ( Q30/1 - 81) was jumping out. Replaced bearing and did old safety wire around the retainer trick. The trick to finding it was to liftup the sort swing assmy (fg6-7500-000 )and turn fs5-0677-000 and check for binds and up and down motion. Seems so easy once you found it!!!! Thanks to all that helped .

Later Warren