IR LBP3580 e000-0000 reset

[Thom]

I lost a sale today because I couldn't find any information on how to reset the fuser error on this machine. I got into the service mode <reset and stop buttons while powering up>, but couldn't get any further. The fuser tested good, but they had a power outage, so I assume it threw the code. For future reference, can anyone help with the reset procedure for this machine? thanks in advance!
Thom

[dan7777]

Re: IR LBP3580 e000-0000 reset

I lost a sale today because I couldn't find any information on how to reset the fuser error on this machine. I got into the service mode <reset and stop buttons while powering up>, but couldn't get any further. The fuser tested good, but they had a power outage, so I assume it threw the code. For future reference, can anyone help with the reset procedure for this machine? thanks in advance!
Thom

Hope this helps. I don't have any of these models so I have not had the issue.
E000-0000 Fixing startup failure 1) Reconnect the connector on the
Engine Controller PCB.
2) Turn OFF the power supply
switch, and remove the Fixing
Assembly. Measure the resistance
value between the connector
(FSRTH) at the Fixing Assembly
side and grounding. If the
resistance value is not between
368k ohm and 512k ohm (normal
temperature), replace the Fixing
Assembly.
3) If the connector at the Fixing
Assembly side does not have
induction while the assembly is
removed, replace the assembly.
4) Replace the Engine Controller
PCB.

■■SP.ADMIN.MODE
Item Description Setting Range
MAINTENANCE C. Special Management Mode -
E355-CLR To clear E355 error. -
NANDROM-ERRCLR
Menu to clear the error code when blocks in NANDROM are
depleted
-
T-5-45
T-5-46