Fusing issues Canon ir3245i

[Valintine]

Hello

I have a Canon ir3245i that has fusing issues. When it came in the fusing sleeve cleaning roller and press roller were pretty bad. I replaced them and still seem to have an issue with fusing. I am usually work on the Toshiba line and if it were a Toshiba I would suspect thermomisters but I do not see thermistors or tempature control parts in the parts book that I have. I would appreciate any help you can offer.

Thank you in advance.

[sharptech1]

Re: Fusing issues Canon ir3245i

Fixing film assembly?

[techwurk]

Re: Fusing issues Canon ir3245i

make sure you have pressure from the LFR

[roho]

Re: Fusing issues Canon ir3245i

What problems are you having? Error codes, poor fixing? Error codes will need to be released in service mode.

[Valintine]

Re: Fusing issues Canon ir3245i

Thank you for the replies. The copies are not fusing properly. I did not touch the pressure springs and followed the directions on the line up of the gear that is used to adjust pressure. I will pull the fuser again and see if I missed something.

[5ercar]

Re: Fusing issues Canon ir3245i

Did you change 2bearings an bushes with pressure roller?

Fuser film original.

Last resort in higher fuser temp
Fx- temp. From default to 7

Once i had cheap toner, did want to fuse at all, if that is the case you have to change it and vacum toner from development unit

[Harry]

Re: Fusing issues Canon ir3245i

Mount the right pressure roller there is a differenz 3225 and 3245 mayby it is the wrong one
harry