[Misc] ir adv 8285 - stapler finisher N1

[wassem]

hi everybody

i want to ask in this finisher if it goes into function limited the speed of the m/c slows down

the error in that finisher is E583-8001

the finisher do not accept firmware upgrade

any suggestions i will appreciate

[teckat]

Re: ir adv 8285 - stapler finisher N1

how are u doing this finisher firmware
---------------------------------------------------------------------------------------------------------------------------------------

Limited Functions Mode for the imageRUNNER Advance Series is found in a special location as opposed to all other imageRUNNER Models.

Please execute the following keystrokes to find Limited Functions Mode.

Settings / Registration > Management Settings > Device Management > Limited Functions Mode


================================================== =============================
E583 -8001 -05
a. Error in stack delivery auxiliary tray operation (Finisher-Q1)
b. Error in the Tray Auxiliary Guide Motor (Finisher-N1)

Detection description
a. Stack delivery auxiliary tray HP sensor does not come ON within 5 sec after the stack delivery auxiliary tray motor
starts operation.
b. The tray auxiliary guide does not come off the Tray Auxiliary
Guide Front/Rear HP Sensors when the Tray Auxiliary Guide Motor has been driven for 3 seconds.

Remedy
a-1. Connector check of stack delivery auxiliary tray motor and stack delivery auxiliary tray HP sensor

a-2. Replacement of stack delivery auxiliary tray motor and stack delivery auxiliary tray HP sensor

a-3. Replacement of finisher controller PCB
b-1. The connector of the Tray Auxiliary Guide Front HP Sensor (S137) or the Tray Auxiliary Guide Rear HP Sensor
(S136) are disconnected.
b-2. The connector of the Tray Auxiliary Guide Motor (M120) is disconnected.
b-3. The wiring of the Tray Auxiliary Guide Front HP Sensor (S137) or the Tray Auxiliary Guide Rear HP Sensor (S136)
are faulty.
b-4. The wiring of the Tray Auxiliary Guide Motor (M120) is faulty.
b-5. The Tray Auxiliary Guide Front HP Sensor (S137) is faulty.
b-6. The Tray Auxiliary Guide Rear HP Sensor (S136) is faulty.
b-7. The Tray Auxiliary Guide Motor (M120) is faulty.
b-8. The Finisher Controller PCB is faulty.