I can't remember.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Cipher
    It's not easy being green

    1,000+ Posts
    • May 2006
    • 1309

    #1

    I can't remember.

    Can anyone recall which service mode allows you to TEST a new drum unit for 100 prints WITHOUT the chip on the drum being written too / read by the machine?

    I was told, but I've slept since.
    • Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.

    Fully qualified technician for Ricoh - Canon - Sharp - HP - Brother
  • Tricky
    Field Supervisor

    Site Contributor
    2,500+ Posts
    • Apr 2009
    • 2620

    #2
    Re: I can't remember.

    from IRC3380 manual

    copier > function > install > AINR-OFF

    Walm-up-rotation disable setting at initial installation
    This disables the initialization of the P-CRG which is performed when a new P-CRG has been inserted. It prevents the
    fuse from blowing when the P-CRG initialization has been completed.
    It is used when replacing the P-CRG and checking the images in situations when, for instance, the causes of trouble are
    identified. When it is set to "1," the initialization is canceled and the fuse is not blown even when a new P-CRG has been
    inserted.
    Settings
    0: Initialization is performed when a new unit is inserted. The fuse is blown.
    1: Initialization is not performed when a new unit is inserted. However, the fuse is melted after the 100 page print and
    the set in service mode goes "0".
    [Factory setting/value after clearing RAM: 0]

    Comment

    • Cipher
      It's not easy being green

      1,000+ Posts
      • May 2006
      • 1309

      #3
      Re: I can't remember.

      That's the one.

      Ta.
      • Knowledge not shared, is eventually knowledge that becomes lost... like tears in the rain.

      Fully qualified technician for Ricoh - Canon - Sharp - HP - Brother

      Comment

      Working...