Hello together,
with me is about an IR C5051. This goes after 5 minutes into the 0W standby. So far everything is good. Now the printer sproradically again wakes up and drives completely up and goes after 5 minutes back into the standby. SNMP packets are sent from the PCs to the device. It is understandable, of course, that the constant change in the standby is quite annoying. Is there a possibility that the device responds only when is actually printed? The device goes otherwise every hour 12 times in the standby.
Many thanks ever for ideas
with me is about an IR C5051. This goes after 5 minutes into the 0W standby. So far everything is good. Now the printer sproradically again wakes up and drives completely up and goes after 5 minutes back into the standby. SNMP packets are sent from the PCs to the device. It is understandable, of course, that the constant change in the standby is quite annoying. Is there a possibility that the device responds only when is actually printed? The device goes otherwise every hour 12 times in the standby.
Many thanks ever for ideas