Help!! iR C3080 Machine

[q555]

Kindly Check Image for your reference.

second image was when i replaced the registration clutch, but there is still slight fold in the middle.

how to resolve this issue?

thanks

[zoraldinho]

Re: Help!! iR C3080 Machine

Only first one or two prints or always?

First start with fresh,dry paper.
Inspect and lubricate thin orange roller in fixing unit.
Inspect>remove>foam dumpers.
Clean or replace pickups and feed rollers.

[tech28]

Re: Help!! iR C3080 Machine

Internal finisher? No finisher? Check switch right before sync roller, steel cover on switch, guild plate out of alignment. just a couple of thing to also check.

[q555]

Re: Help!! iR C3080 Machine

Only first one or two prints or always?

First start with fresh,dry paper.
Inspect and lubricate thin orange roller in fixing unit.
Inspect>remove>foam dumpers.
Clean or replace pickups and feed rollers.

when i haven't change the registration clutch, every output is the first picture.

after replacing the registration clutch, second picture was the output.

[q555]

Re: Help!! iR C3080 Machine

Internal finisher? No finisher? Check switch right before sync roller, steel cover on switch, guild plate out of alignment. just a couple of thing to also check.

the machine is without inner finisher. i have tried also remove the plate, and reseated it. i've also cleaned some parts.

what else can you recommend?

thanks

[zoraldinho]

Re: Help!! iR C3080 Machine

when i haven't change the registration clutch, every output is the first picture.

after replacing the registration clutch, second picture was the output.

I understood you the first time.Don't make me to come on philippines! This model have many reasons for this kind of problem.With new clutch you eliminate 80% of problems.Did you check things from my previous post?

[q555]

Re: Help!! iR C3080 Machine

I understood you the first time.This model have many reasons for this kind of problem.With new clutch you eliminate 80% of problems.Did you check things from my previous post?

i havent' check your post. Kindly post the link here, please? Thank you so much.

[techandtrader]

Re: Help!! iR C3080 Machine

Most likely Fuser unit. Before you change it. Open the fuser and put a drop of oil on the ends of the skinny orange roller. This is on the outside guide. If you want to do it by the book, remove the assembly and apply conductive grease to the ends. This pencil size roller can cause a drag on the paper and make the bends.

If that doesnt work its time for a new fuser.

[q555]

Re: Help!! iR C3080 Machine

hi good day.

we have recently changed the fixing unit.

second picture is still the output.

[techandtrader]

Re: Help!! iR C3080 Machine

Can you make a copy through the manual feed without any noise or studder? Is the lower door hinge cracked or loose.

[q555]

Re: Help!! iR C3080 Machine

Can you make a copy through the manual feed without any noise or studder? Is the lower door hinge cracked or loose.

Hi, i've tried all trays and manual feed, same output. The door don't have any broken parts.

My last resort i think, i will replaced the guide plate. I will update as soon as i replaced the guide plate.