Ira c5051 e027-0100

[Mikecanon]

Well my company purchased a ira c5051 with the simple error of 027 which usually is the coupling of the dev unit which i replaced but did not help. I chose to replace the whole unit but still had the error i even replaced the hooper, dc controller, motor, and the drum driver this is not only another job for me but it became personal after a simple error has given me a huge headache any advice is well taken thanx yall

[mosey1100]

Re: Ira c5051 e027-0100

Well my company purchased a ira c5051 with the simple error of 027 which usually is the coupling of the dev unit which i replaced but did not help. I chose to replace the whole unit but still had the error i even replaced the hooper, dc controller, motor, and the drum driver this is not only another job for me but it became personal after a simple error has given me a huge headache any advice is well taken thanx yall

Did you also check the end of the Developers to make sure that drive coupler wasn't broken?

[Mikecanon]

Re: Ira c5051 e027-0100

Did you also check the end of the Developers to make sure that drive coupler wasn't broken?

Yes sir this has been one tricky error

[Mikecanon]

Re: Ira c5051 e027-0100

Any suggestion is more than welcome been stuck on this one all week guys thank you

[dan7777]

Re: Ira c5051 e027-0100

Well my company purchased a ira c5051 with the simple error of 027 which usually is the coupling of the dev unit which i replaced but did not help. I chose to replace the whole unit but still had the error i even replaced the hooper, dc controller, motor, and the drum driver this is not only another job for me but it became personal after a simple error has given me a huge headache any advice is well taken thanx yall

[NorthW]

Re: Ira c5051 e027-0100

I would look at the drum encoder sensors, they can get full of dust and cause errors too, you never know.

[apoxi]

Re: Ira c5051 e027-0100

Well my company purchased a ira c5051 with the simple error of 027 which usually is the coupling of the dev unit which i replaced but did not help. I chose to replace the whole unit but still had the error i even replaced the hooper, dc controller, motor, and the drum driver this is not only another job for me but it became personal after a simple error has given me a huge headache any advice is well taken thanx yall

I had this error. When i was replacing the hooper the error was gone.

[godwin2017]

Re: Ira c5051 e027-0100

please can anyone help me with how to remove the hopper unit

[guitar9199]

Re: Ira c5051 e027-0100

please can anyone help me with how to remove the hopper unit

The Service Manual has a pretty simple walkthrough on removing the hopper units, beginning on page 396 (Chapter 4-133). Follow through all of the steps in order, and you should be able to replace the hopper easily.