e: Jam with code 0111 on iR -ADV 6075

[mramlawi]

Dears ,

first time i faced like this problem, the paper. Jaming on one sided jam 0111 , the paper didnt ente the heater its just bent while passed through the fixing inlet sensor and stopped tried all the drawers same problem on sided and two sided .i cleaned the itb , clear main clear dc changed new pre-transfer ,on a4 -R
it works.

can any one help

[rudysemira]

Re: e: Jam with code 0111 on iR -ADV 6075

Dears ,

first time i faced like this problem, the paper. Jaming on one sided jam 0111 , the paper didnt ente the heater its just bent while passed through the fixing inlet sensor and stopped tried all the drawers same problem on sided and two sided .i cleaned the itb , clear main clear dc changed new pre-transfer ,on a4 -R
it works.

can any one help

Check the fixing unit if the roller is rotating if doesn't check the fixing drive gear if not broke...

[mramlawi]

Re: e: Jam with code 0111 on iR -ADV 6075

Check the fixing unit if the roller is rotating if doesn't check the fixing drive gear if not broke...

The fixing is rolling normally ,and the paper didnt enter the heater and it jama look like transfer problem

[roho]

Re: e: Jam with code 0111 on iR -ADV 6075

Fuser gear would kick a E014 code. Try replacing both coronas and the ETB.

[mramlawi]

Re: e: Jam with code 0111 on iR -ADV 6075

Fuser gear would kick a E014 code. Try replacing both coronas and the ETB.

Thank u will try to change the itb

[mramlawi]

Re: e: Jam with code 0111 on iR -ADV 6075

Thank u for ur help , my problem solved after i changed the itb

[roho]

Re: e: Jam with code 0111 on iR -ADV 6075

Thank u for ur help , my problem solved after i changed the itb

To keep that ETB fresh, change the coronas as well!!!

[mramlawi]

Re: e: Jam with code 0111 on iR -ADV 6075

To keep that ETB fresh, change the coronas as well!!!

Corona ??? U mean the primary and pre transfer ?why then ?

[roho]

Re: e: Jam with code 0111 on iR -ADV 6075

As the coronas wear down, especially the primary, they will begin to degrade the ETB, causing it to wear out sooner and leave marks on prints, or jamming in your case. Some things are worth changing in the long run.