On canon IR finisher. Could this be the ribbon cable. As paper drops in swing guide to staple, the machine error codes. Stapler moves to rear ready to staple?
E531
Collapse
X
-
paulpa66
it says:
E531 8001 Staple
motor(M111)/
Staple home
position detect
sensor(PI50)
The stapler does not return to the staple home position when the staple motor has been driven for 0.5 sec.
8002 The stapler does not leave the staple home positionwhen the staple motor has been driven for 0.5 sec.
Is this refering to the stapler itself, i'e the opening and closing of stapler or the cariage back and forth, as that seems ok?
Stapler moves by hand, but when stapling as i say, paper falls in to be stapled, but instaed of stapler trying to staple, it just errors. Stapler appears ok, nothing obvious.Comment
-
So the stapler moves back and forth on the runners ok?
I had a finisher this week that would only staple one side of a saddle stitched job...no error codes.
On inspection I found the stylus for the copier had dropped down in the path of the carriage.Comment
-
Comment
-
-
-
Comment
Comment