[Error Code] Canon IR 6570 Error 100 - 001

[zelotprotos]

My IR 6570 boot normally and display "READY" on the panel.
If I make a copy job and when the paper enter the developing unit , it will always stop there and give an error 100 - 001 display on the panel.
I have try to replace : Laser Unit, DC Control, and Power Supply Unit, and not make any change.
Please give me some advice how do I solve this error problem? Thank You

[nicknt82]

Re: Canon IR 6570 Error 100 - 001

My IR 6570 boot normally and display "READY" on the panel.
If I make a copy job and when the paper enter the developing unit , it will always stop there and give an error 100 - 001 display on the panel.
I have try to replace : Laser Unit, DC Control, and Power Supply Unit, and not make any change.
Please give me some advice how do I solve this error problem? Thank You

You can follow below information
2.jpg

[zelotprotos]

Re: Canon IR 6570 Error 100 - 001

You can follow below information
[ATTACH=CONFIG]41843[/ATTACH]

thanks for the information, but I have already checked it,

[techandtrader]

Re: Canon IR 6570 Error 100 - 001

Turn off potential Cont. If it runs you need a new sensor.