Canon ImagePress C6000 registartion problem

[Laka]

Hi!
What is wrong if registartion is good on one side, and not on the other ( left-right) ..!?
Pls se picture!
Regards
Lars
grid-1.jpg

[Hishamawada]

Re: Canon ImagePress C6000 registartion problem

Hello ,
i don't know if you still have the issue or not ,
since the colors is skewed , it is not a normal color mismatch , mechanically it could only be a lasers issue , but since its on more then 1 color then i suggest it to be a software issue , it could be that there is parameters to adjust the laser skew and it would be fit on each other perfectly .

Itb, developing assemblies, secondary transfer will not cause such a problem .So first i would like you to check the glasses for the lasers and clean them properly then perform init-itb and adj-img-X (several times) if no improvement , you can try clearing the DC con and test before restoring the backup , if no improvement i suggest to check the lasers.

If the issue have been solved i would like you to tell me what was the solution .

Good luck

[Laka]

Re: Canon ImagePress C6000 registartion problem

Hello!
Thanks for the information!
The machine is on "hold" for the moment ..., but a will try this asap!
Regards
Lars