Canon iR6000 hard drive swap possible?

[Juxta5]

I have a general question about an iR6000 hard drive.

I have one used machine with a good hard drive but a bad drum, bad developing unit and high meter, and one used machine with a bad hard drive but a good drum and low meter.

Can I simply swap the hard drives from one iR6000 to another? Would I still need to run the SST after a swap?

I work with Konica/Minolta's, but have these Canon's in our office that I need to do something with. I've checked the price on replacement parts and for these older machines, I don't think new replacement parts are worth it -- better to make one decent used machine. I don't want to throw them away, I have multiple good finishers too. Arrrg.

[Guest]

Not always require to reload

Not always require to reload. If the good hard drive has the same firmware on it then its possible. If anyone one of them is a network printer then the program or firmware must be loaded for network, also the boot rom must be updated. If all is the same you should have no problem.