IR 2200 error code 220

[Kurt]

I've checked all wiring to make sure I have good connections. Anyone seen this problem. Thanks, Kurt

[banty]

Solution

I've checked all wiring to make sure I have good connections. Anyone seen this problem. Thanks, Kurt

Hi Kurt,
If there is a sub code 0001 A fault is detected on the inverter PCB for the scanning lamp.
Main cause The inverter PCB is faulty. The reader controller PCB is faulty. So, check it out .

regards

[costd]

All I can offer is From Canon:

Problem :
The machine displays an error code of E220. The code only displays when copies are made off the glass. Originals copied using the Document Feeder do not cause the code to occur.

Solution :

Unplug the copier and remove the Copyboard glass. Move the scanner manually and check to see if the Scanner Home Position Sensor Flag is coming into contact with the Inverter Pcb, or any of the wiring. Contact with the flag may be causing a short during Scanner movement when copying from the glass.

Problem :

Error Code E220-0001 occurs after replacing the Lamp, Inverter PCB and the Reader Controller.

Solution :

Check and verify the 24V supply to the Reader Controller from the Main Power Supply (Switching Regulator) is present. It is possible that one of the loads on the DC-Controller can take down the 24 volts. Remove the 24volt loads off the DC-Controller and connect the connectors one by one to locate the short or defective load.