Change Boot Room From C To N IR 5000

[Guest]

Hi nice people....

can u help me, how to change boot room ir 5000 from c to n?

thanks before...

[copymon]

Boot rom located on right side, remove small metal plate for access.

[nivssluck]

There is a special hardware to change botroom from C to N. I don't know if there is special software to flash bootrom from C to N. For me am using IR5000 for flashing bootrom. It can handle IR5000, 6000, 3300, 7200, 8500 and 105 together with SST.

[Guest]

You need to purchase print kit, comes with nic card, ram, and bootrom.

[jtecks]

You cannot flash a C up to an N. Buy the print kit if you can. Canon does not supply them anymore.

[mrfixit51]

Buy the print kit if you can. Canon does not supply them anymore.

Jtecks is correct,,, but they can be found out in the e-world at sites such as e-Bay

Canon Network MultiPDL Printer Kit IR5000 - eBay (item 250329802644 end time Mar-21-09 19:55:33 PDT)

[bnmand]

Jtecks is correct,,, but they can be found out in the e-world at sites such as e-Bay

Canon Network MultiPDL Printer Kit IR5000 - eBay (item 250329802644 end time Mar-21-09 19:55:33 PDT)

You can get them cheaper than that.

It's a pity other accessories are not so readily found on places such as eBay.

[Electrictoner]

ir 5000 c to an N

Hi

I had this issue a while back. You cannot get N by itself. I have a few N Roms from dead machines I would sell. You still need a NIC card (also have) if you want TCP/ip and you will need to do a SST after N install but it will work (I've done it) and if you dont get the NIC card the centronics port will work you can even use a CAt 5 to centronics printserver. Hokey but it works, let me know if its a plain 5000 or a 5020 or 5000s BTW have same for Ir 8500 and 105's

Billy
>>>>intocopy@yahoo.com<<<<<<<<<