Canon CLC-2620-C2 - only halftone

[Guest]

Hello again,

I gave it up to use my other device (CLC3220-C1), after last crash I had much problems with it.
After 10 Copies I had yellow shadows until 30% of each side.
The percentage of used parts of the transfer belt, second transfer roll, and drums are about 300%.
That are too much parts to change at the moment.

My other problem is, I have bought 4 weeks ago another used device with total about 50.000 copies.
Until yesterday, the copymachine CLC-2620-C2 worked perfektly, beautiful pictures, nice folders,...
But without any changes, with same Options I have now on every document only halftones, much white points and very bad graphics.

Until now I made a full automatic adjuct, changed some toners, have reseted the device and tried to print with PS and PCL drivers, the result is the same.

Is there any option to set the device back again to print in full resolution ?

The other thing is, in the preview option of the Command Workstation, the printquality is fine, so it must be any error inside the maschine.

Please, help me to solve this problem, I have some important prints on queue.

Many thanks.
Andreas

[Guest]

Is there any option to set the device back again to print in full resolution ?

The other thing is, in the preview option of the Command Workstation, the printquality is fine, so it must be any error inside the maschine.

Check the seting "Reduse Toner" in driver

[ABW]

Thanks for your reply,

the option is deactivated

i have reinstalled all drivers, but still the same problem.

In another forum had one the same problem with a canon printer,
but it was a small copy printer, the solution was to change the ATR sensor.
I have searched through the internet for similar posts for my printer,
but there is nothing.

Any other ideas what is could be ?

Some more informations:

I have just made a copy directly on the station, the result is ok.

So it must be an error on the printer controller.

Type: FIERY X3IM-DDI-01 BB - 7 segment displays:00