I understand that there are cases about this being solved with an updated spring/ sensor or magnet height on the puncher. I thought it might be worth posting a pic of this area.
If I open up the puncher for whatever reason the inlet guide isn't going to get back under the copier side guide EASY like we want it to. This for 20231110_105934.jpgsure could contribute to this very intermittent jam. This is the N1 and it is leveled and latching properly but I am preparing to go back over the procedures. FYI when 2 sided paper is running timing is critical in this area. You might have something to add?
If I open up the puncher for whatever reason the inlet guide isn't going to get back under the copier side guide EASY like we want it to. This for 20231110_105934.jpgsure could contribute to this very intermittent jam. This is the N1 and it is leveled and latching properly but I am preparing to go back over the procedures. FYI when 2 sided paper is running timing is critical in this area. You might have something to add?