ir5000

[T911]

is there suppose to be a special usb-parallel cable to upload the software into a new hdd for the 5000. i have the sst and software but keep getting 11 codes and e200 along with the software isn't connected to the proper model doesn't match. i have it in ecp mode through the bios of the computer but can't seem to get this one to work. thanks t

[Guest]

is there suppose to be a special usb-parallel cable to upload the software into a new hdd for the 5000. i have the sst and software but keep getting 11 codes and e200 along with the software isn't connected to the proper model doesn't match. i have it in ecp mode through the bios of the computer but can't seem to get this one to work. thanks t

If you are getting this"the proper model doesn't match". You are most likely using the wrong firmware. If your laptop does not have a parallel port, then you will need the nethawk cable, which is almost impossible to get. If your trying to use some other type of USB to parallel cable, you will run into some problems.

[bnmand]

If you don't have a nethawk (special no longer produced Canon usb-to-parallel cable) use a computer with a parallel port. You will need an IEEE1284 bicentronics parallel cable (not just any old parallel cable) as you require two way communication. If you have an old scanner which uses a parallel cable that will probably be an IEEE1284 one.

[waynec]

Hi you can use a cable supplied by Canon it is called a Nethawk cable, you will be required to install the driver which is included with the SST once you have done this you will then be able to upgrade firmware. The adaptor cables supplied by your normal computer supplier will not work.

[smiley]

hi i have a nethawk driver.if you want i will send it to you.that's why when my boss gave me a laptop dell inspiro i still use my compact armada 500 a very old but reliable latop a little bit slower but i can used it in older ir series that require parallel port with no problem.