3220 out of registration

[Juelis]

The prints are coming out of record. Already changed belt, already calibrated the machine, already adjusted the laser, but nothing helped.
Does anyone have a clue?

Thanks!

[Guest]

When you change the belt, was it replaced with a new one?
How did you adjust the lasers; what procedure?

Two options more:
1) Upgrade firmware,Dc-con and R-con.
2) Replace Dc-con PCB

[THUK]

HI,have you tried clearing dc con then do a couple of auto grads,the life itb assy is 300k change whole assy then do dccon clear and 2 auto grads.

[welshman]

also when you do dc con clear leave the door open as it wont clear the reg settings if you dont

found this out for a canon trainer 6 mnths ago he did not think it mattered till he had a problem machine and i told him to leave door open when did dc con clear it worked after 3 calibrations then

[Guest]

also when you do dc con clear leave the door open as it wont clear the reg settings if you dont

found this out for a canon trainer 6 mnths ago he did not think it mattered till he had a problem machine and i told him to leave door open when did dc con clear it worked after 3 calibrations then

Interesting.

[Van Steal]

don't forget to get a P Print from the printer as you will need to re-enter the settings for the dc-con

[Juelis]

Solved.

@SCREWTAPE
I swapped for a new belt.
"How did you adjust the laser, what procedure?"
I printed the "P Print" then I was changing the values of the laser to go on record.
__________________________________________________ ____________

He had also trying to reset the dc con.
And when did it also print the values! D;

I solved the problem, but otherwise!

First reseted the dc con (again), then did the calibration 3x
was not 100% ... then I went into "Additional Functions>> Common Settings>> Text / Photo / Map>> I changed to" Text Priority "

After that was very nice prints/copies.

Thanks a lot for all the tips, and divide my experience with you.
Thanks Men.

\ o /