Can anyone help me for the problem of IRC3200. the problem occured with the potho, posted on this page. When i tested PG;type 6, it appeared like the sensors of each color not be in the line. Then i tried to change ITB, and the problem was the same. after that, i tried to take away my old DC control PCB to test with another one, and the results came out the same. the last one, when i changed NEW DC control PCB, what shit man. my new one had broken.
-
-
You need to realign the laser units....in fact(from memory) you can swap the color laser units around.
But your issue appears to be the laser units needing to be realigned. -
Yes just align the laser but swapping them around is not a good choice.
I use to do the same but what i notice was that, they are values on each laser unit that are pertain to each color in service mode under laser adjustments. Though i never encounter a issue yet by doing so, just aligning them will do. Good luckComment
Comment