Clc4040 e747-800

[Guest]

Hi Guys,

Seen a bit of info over the past re E747-800 whcih mostly mentions Main Controller. Before we go that expensive route has anyone had any other causes of this code.
On our CLC it RIPs the job fine but throws the code just as the machine kicks in!

Many thanks

[mrfixit51]

some questions to get things rolling...

Does the copy function work O.K.? Do all print jobs do this, or is it related to only a single specific print job? Do machine generated test prints work O.K.?

[firstoffice]

Ok on copying....but all the time on print jobs...no matter how small.

[Van Steal]

Try resitting all the PCB on the main controller

[alex@wocltd.com]

have you tried another rip?
is it a h1 ? is it running latest v2 firmware?
is machine v3 firmware?

[binks24]

[alex@wocltd.com]

Hej Binks24,

Arbetar du i Sverige?

Hur ar kopierings-branschen och hur ser arbetsmarknaden ut dar?

Hur bra maste min svenska vara (min fru skriver detta at mig)? Vi planerar att flytta till Sverige och skulle uppskatta lite tips.

Alex

[binks24]