Just got this copier, and this error code comes up. It only happen when finisher is connected. Don't have service manual. If anyone has one I would appreciate a copy. Any ideas?
-
-
This should help
E584
Main Cause The shutter open sensor (PI5) is faulty. The safety area detecting switch
(MS3) is faulty. The shutter closed detecting switch (MS4) is faulty. The
No. 2 feed motor (M8) is faulty. The finisher controller PCB is faulty.
Mode of
Detection
0001 The shutter closed detecting switch does not turn on when the No.
2 feed motor has been rotated CCW for 1 sec or more.
0002 The shutter open sensor does not turn on when the No. 2 feed motor
has been rotated CCW for 1 sec.
0003 While the tray lift motor is in operation, the shutter closed detecting
switch is found to be off when the tray 1/2 is at OFF position
of the safety area detecting switch.
Regards
sigpic
Life is a Journey enjoy the ride !!! -
Hi,
Also may help
Shutter open sensor PI5 fallen out of position may of come loose in transit as not secured with glue.
Remove shutter assembly to refit sensor.
ShazzaComment
Comment