Ok guys,
Its not the drawer connector on the fixer unit(top LH side)
Tested the conn. thru the drawer connector (6) of them
connector is not damaged and very clean
All connections to the heaters and sensors good to the AC pcb.
all door switches good
No errors on startup/boot.... just sits cold
Its got to be something really simple
The AC PCB triac board is just not getting the signal to turn"on"
If you read the last few posts on this it will tell you where I have been on this, were getting close to finding what its not but this ones a tough one
I dont think a DECON clear/reset is needed nothing was turned off in the service mode
OK Just cked the AC driver PCB, Triacs Board is ,good
Just Cked the AC sub board. Good
cked J1185 and J1186 to drawer connector, good
J1810 connector to J1113A-1113B on CD control PCB +3.3 and +13 Good
The DC control PCB?
LED 1 Blinking on DC control pcb
The Main AC relay is good!
come on guys this is kicking my ass on this one
Its one of those "OH SHIT I missed that !" ones.
Thanks
Its not the drawer connector on the fixer unit(top LH side)
Tested the conn. thru the drawer connector (6) of them
connector is not damaged and very clean
All connections to the heaters and sensors good to the AC pcb.
all door switches good
No errors on startup/boot.... just sits cold
Its got to be something really simple
The AC PCB triac board is just not getting the signal to turn"on"
If you read the last few posts on this it will tell you where I have been on this, were getting close to finding what its not but this ones a tough one
I dont think a DECON clear/reset is needed nothing was turned off in the service mode
OK Just cked the AC driver PCB, Triacs Board is ,good
Just Cked the AC sub board. Good
cked J1185 and J1186 to drawer connector, good
J1810 connector to J1113A-1113B on CD control PCB +3.3 and +13 Good
The DC control PCB?
LED 1 Blinking on DC control pcb
The Main AC relay is good!
come on guys this is kicking my ass on this one
Its one of those "OH SHIT I missed that !" ones.
Thanks