CANON SST for CLC5000 series

[berni911]

Hi everybody!

I'm looking for Canon SST 1.17 or similar for the CANON CLC 5000.

Perhabs it has someone on his hdd :-)

Thanks a lot

[charm5496]

It has been a while, but I am pretty sure that the CLC-5000 did not connect to any SST. This device did not have a HDD or rewritable ROM chips in it.

[berni911]

Hi,

yes it does. As shown in the Service Manual.

[charm5496]

Double checked myself after reading your reply and I can not find anything on SST on this unit. Is the model machine you are working?

Or are you working on a different european version of an IRC?
The CLC series used a program called PCB downloader here in the US

[teckat]

Upgrading
The CLC5000 is equipped with two DIMMs (4 MB and 2 MB each) on
which a flash ROM is mounted; one of the DIMMs is used to store
Firmware for the reader controller (4 MB) and the other is used to store the
Firmware for the DC controller (2 MB). A Personal Computer is required
when installing upgraded firmware. Use Bicentronics I/F cable6 as an
interface between the personal computer and the CLC5000 to enable
high-speed transmission of the data. The required time to complete the
upgrade is approximately ten minutes.
The firmware may be upgraded in any of two ways:
1) Downloading using a PC
or
2) Replacing the DIMMS


Last update was in 2004>>>>>>DCON v12.03 RCON v12.07

[berni911]

Hi teckat,

the same in my SM :-) But nobody has the software... :-(

[teckat]

on the way ~~~~~~~~~~~~~~~~~~~>

[berni911]

Thanks!!!!