canon irc3220 not booting up

[Guest]

i can't get this machine to boot up properly,goes to wait screen and 3 quarters of the bar then display just goes black,have tried 2 different hard drives ,hdd check etc ,still nothing any ideas ?

[kuby]

Is the fuser getting hot? Had one doing the same thing, fuser had a short.

[kennyjmac]

will check that out but it doesnt boot up ,was it a fuse in the fuser itself or in the fuser control pwb thanks

[teckat]

Try removing the boards plugged into the Main Controller one by one to try and isolate which one could be causing the problem. If all the boards check out fine you may have a bad SRAM PCB

[SCREWTAPE]

i can't get this machine to boot up properly,goes to wait screen and 3 quarters of the bar then display just goes black,have tried 2 different hard drives ,hdd check etc ,still nothing any ideas ?

Is this still the same 3220 from a couple weeks ago kenny?

[kennyjmac]

afraid so only got back to look at it again this week in wshop running out of ideas and unfortunately not got a donor machine to try boards etc with