If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Fixing Error= / were u working on unit before error ?/ did u have a paper jam in it/
+ check actuator for the fixing inlet sensor/ can break or become sluggish and cause an error code E001
actuator (FC5-5145-000) and the return spring (FU5-2175-000).
**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Fixing Error= / were u working on unit before error ?/ did u have a paper jam in it/
+ check actuator for the fixing inlet sensor/ can break or become sluggish and cause an error code E001
actuator (FC5-5145-000) and the return spring (FU5-2175-000).
yes i have a paper jam and clear it, i also have check and clean thermistor, shutter thermistor it's ok.
i will check actuator sensor and return spring thank's for this teckat
How about clearing the code E001 in service mode. Did you get to do this yet.
E001-xxxx Must be cleared by service mode. Copier>function>clear>err>ok then reboot.
How about clearing the code E001 in service mode. Did you get to do this yet.
E001-xxxx Must be cleared by service mode. Copier>function>clear>err>ok then reboot.
yes after clearing error code i get the same code after machine ready for about 2 minute
Comment