If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
As i said before, you have to find the right amount of pressure.
I had three finishers doing this same skewing issue and the adjustment worked.
I haven't went back again.
The beasty I had to perform this on took me a few visits to "fine tune" it... It has behaved ever since as well..
"Once a King, always a King, but once a Knight is enough!"
Comment