iRc3580i -ITB,DRUM PROBLEM

[hemai2005]

Hi guys.I have a canon irc3580i
the problem starting when the message appear (insert cyan drum),i removed the drum from the machine and i find some plastic cuting inside it between gears and also some defective on the ITB ,and this plastic detected represent the internal edge of ITB,i take new drum cyan, and ITB to solving this problem also new black drum to safe, but unfortunately
problem is still,and this test page before and after.
Notes this new machine ,counter 6000 only
can anybody help me solve this problem all the focus
thanks

[hemai2005]

a2j_SAVE0064..jpga2j_SAVE0065..jpga2j_SAVE0066..jpga2j_SAVE0067..jpgsorry this attachment for the problem

[CanonWes]

drum drive

there is a white drive connector in the machine that may be damaged they should push in a spring out by themselves. this happens when the rubber edge comes off the itb and jams the drum.

[hemai2005]

no response from anybody

[hemai2005]

again no response or sharing from anybody

[Canuck]

Well for one thing when you pop a new drum in the machine,a fuse blows on the drum unit telling machine new drum and reset software counter for drums. When testing with drums, go in service mode,function,install,and set AINR_OFF to 1. This will prevent the fuse on the drum unit from blowing. This machine determines the presence of a drum by measuring the primary roller AC bias. Check all the contacts in the ITB/drum processor assy...primary,transfer,etc. Usually replacing the ITB assembly gets rid of this message,but you state that you have already done this. I would bring in other color drums(used will work) to see if problem changes. Bad drums will cause funky problems on these machines.

[hemai2005]

Dear all
this problem solved by replacing the transfer cleaning unit ,ok ,machine fine and everything is ok
but but my Qt. now what is the causes of this problem? ITB & T.cleaning unit defective both with two drum (big problem) case closed.
and today also happened with another customer damage to the ITB and the machine( iRc2380) & counter 28,000 only ,can anybody tell me why??
environment or technical bulltine or bad ITB from canon or what happens in this series ?
thanks