iRC3200 with error code E732 & E733

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Blues Guy
    Trusted Tech

    100+ Posts
    • Aug 2009
    • 216
    #1

    iRC3200 with error code E732 & E733

    Hi guys,

    Need advice anyone have come across these error code when the machine start to print. After you OFF/ON back the machine you can print and is a intermittent problem.

    Parts have replace is main controller. The boot rom and the ram have clean it with a contact cleaner only.

    Any comment
    Tags: 200, act, advice, amp, back, boot, clean, clr, code, controller, e732, error, error code, intermittent, irc, irc3200, main, print, replace, roller, sea, start
    • teckat
      Field Supervisor

      Site Contributor
      10,000+ Posts
      • Jan 2010
      • 16083
      #2
      Originally posted by Blues Guy
      Hi guys,

      Need advice anyone have come across these error code when the machine start to print. After you OFF/ON back the machine you can print and is a intermittent problem.

      Parts have replace is main controller. The boot rom and the ram have clean it with a contact cleaner only.

      Any comment
      E732=
      If the Reader (outside interface cable ) is disconnected from the Printer a E732 code will result. Once the Reader is disconnected the logic on the MAIN-Controller is changed to a "0". The copier is now set up to be a Printer only, and will not recognize the Reader.
      To correct this, you must enter service mode, COPIER>OPTION>BODY>W/SCNR and set that to "1". Then you must turn the copier off, then on.



      E 733=Re-seat the ribbon cables between the Reader Controller and the Interface PCB
      could also be a defective DC Fuse PCB

      Fuse -- Voltage -- Connector -- Destination -- Connector
      FU25- 24vdc - J67-2 - Reader - J565-1
      FU25- 24vdc - J67-3 - Reader - J565-2


      make sure to put back all the door sheet values back in/ also your Rcon numbers after a ram clr.
      Last edited by teckat; 04-20-2010, 06:54 PM.
      **Knowledge is time consuming, exhausting and costly for a trained Tech.**

        Comment

        • Tricky
          Field Supervisor

          Site Contributor
          2,500+ Posts
          • Apr 2009
          • 2620
          #3
          The reader cable plugs into "DDI-S BOARD PCB ASSEMBLY" at the rear of the printer, Remove the rear cover and the controller cover and check the connection to the main controller.

            Comment

            Previous template Next
            Working...