ir2270 E-000110-0001.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Bolla

    #16
    if you update the CPM to higher than 28pcs/minutes,then it is will pop erorr on 2270 machine,
    if the CPM is not more than 28,then if display E110-0001,it is problem of the laser.

    Comment

    • Bolla

      #17
      agree with teckat!

      Comment

      • ymmtech
        Trusted Tech
        • Jun 2009
        • 190

        #18
        Beg your pardon, whats' CPM/?
        Controlled Programming for Microprocessor?

        Comment

        • teckat
          Field Supervisor

          Site Contributor
          10,000+ Posts
          • Jan 2010
          • 16083

          #19
          Originally posted by ymmtech
          Beg your pardon, whats' CPM/?
          Controlled Programming for Microprocessor?

          Copies per Minute '
          **Knowledge is time consuming, exhausting and costly for a trained Tech.**

          Comment

          • ymmtech
            Trusted Tech
            • Jun 2009
            • 190

            #20
            I borrow counter set from another machine, low format HDD with computer, reinstall firmware.
            Put back the original one after firmware install.
            It is now OK. But can not understand.
            Anyway, Thanks Ladies and Gen.

            Comment

            • teckat
              Field Supervisor

              Site Contributor
              10,000+ Posts
              • Jan 2010
              • 16083

              #21
              Originally posted by ymmtech
              I borrow counter set from another machine, low format HDD with computer, reinstall firmware.
              Put back the original one after firmware install.
              It is now OK. But can not understand.
              Anyway, Thanks Ladies and Gen.

              Canon - Image Runner IR 2270



              • * 22 pages per minute
              • * First Copy Time 4.9 Seconds-from Platen Glass
              • * 6.9 Seconds from Feeder
              **Knowledge is time consuming, exhausting and costly for a trained Tech.**

              Comment

              Working...