i have a customer that would like me to replace the waste ink absorber on his canon ip90 bubble jet printer. i can find all sorts of info on where its at and what it is and how to reset the waste ink full message but i can not find any information on how to remove it, or where to buy a new one. the customer said his users manual said to take it to an authorised service center. i can't find any service literature for this printer on canons support site. does anyone know the part number or where i can buy one?
-
-
if this is the first time the message Waste Ink Absorber Almost Full- try this below-
1) Close the print head cover, and turn off the printer. While pressing the Resume/Cancel button, press the Power button. (Do not release the buttons. The LED lights in green to indicate that a function is selectable.)
2) While holding the Power button, release the Resume/Cancel button. (Do not release the Power button.)
3) While holding the Power button, press the Resume/Cancel button three times, and then release the Power and Resume/Cancel buttons. (Each time the Resume/Cancel button is pressed, the LED lights alternately in either orange or green, starting with orange.) During initialization, the LED blinks in green.
4) When the LED stops blinking and lights in green, press the Resume/Cancel button the 4 times. (Each time the Resume/Cancel button is pressed, the LED lights alternately in either orange or green, starting with orange.)
5) Press the Power button. The LED lights in green, and the
selected function is performed. (When the operation completes, the printer returns to the menu selection mode automatically.)
6) Power off then back on and test.**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment