[Error Code] Image Press C1 E25-0004

[radu]

Hi everyone, I have a image press C1 canon copier, that gives me error code E25-00004, can someone help me with this problem please?

I would really appreciate a service manual if anyone has it, I can trade it with another one if need it, just to be fair.

mail e-mail address is cradox@gmail.com, keep in thouch and thank you!
Radu

[mrfixit51]

This is all I could uncover...

*Check the wiring harness from SW15 back to the Side Driver PCB. Check the continuity of the wiring and cut all the wire ties. There could be a short in the harness that intermittently causing the problem your having.

*Cut all wire ties from switch to side driver. It's been a month and still running good

*I had it too. Cut the wire ties from SW15 to the connector. Worked for a day. Had to replace the yellow wiring harness from SW15 to the right side of the hopper.

[radu]

Well, sounds interesting, I shall try tomorrow and I'll give you my feedback , thank you for the quick reply, I guess it doesn't make any sense to ask you about the service manual?

[zoraldinho]

Hi everyone, I have a image press C1 canon copier, that gives me error code E25-00004, can someone help me with this problem please?

I would really appreciate a service manual if anyone has it, I can trade it with another one if need it, just to be fair.

mail e-mail address is cradox@gmail.com, keep in thouch and thank you!
Radu

Check grey hooper locker

snap024.jpg

[radu]

Oh you know what, I might have forgotten that locker opened, I hope that's the case, I would be very happy.
But still, I see nobody wants to trade manuals, hmm....

Thanks zoraldinho and Mrfixit, I'll check the machine today, keep in touch!

[charm5496]

Oh you know what, I might have forgotten that locker opened, I hope that's the case, I would be very happy.
But still, I see nobody wants to trade manuals, hmm....

Thanks zoraldinho and Mrfixit, I'll check the machine today, keep in touch!

I have followed a tech who incduced this error because they did not put the handle to the proper location after working on the machine. Would be a nice easy call if that was the case.

[radu]

Hi guys,

Sorry for not replying for that long, I was really busy and I forgot about the C1, it was as simple as Zoraldinho predicted, I went back and checked that hopper lever, my colleague left it open last time, I forgot to check and obviously that Error code didn't make me think of that, but that was the exact problem.

So case closed and thank you guys for your help!

[zoraldinho]

Hi guys,

Sorry for not replying for that long, I was really busy and I forgot about the C1, it was as simple as Zoraldinho predicted, I went back and checked that hopper lever, my colleague left it open last time, I forgot to check and obviously that Error code didn't make me think of that, but that was the exact problem.



So case closed and thank you guys for your help!

index.jpg1.jpgAny time.