Canon CLC3200 doesnt detect C1 controller after DC-con.M-Con cleared.

[tinnyjay]

Hello
After clearing DC Con and M-Con CLC3200 doesnt detect C1 controller.I am wandering if C1 controller is demaged and i dont have firmware for it,is it possible to change boot rom from C to N.
Can u suggest me something please?
Thank u

[zoraldinho]

Set again IP settings.

[tinnyjay]

Set again IP settings.

On CLC3200's touchscreen there is not PRINTER tab.

[mrfixit51]

After those clears, you need to tell the copier that it has a C1 attached. Copier>Options>Int-Face> set it to 3.

IMG-CONT
Used to set connection to PS print server unit.
Setting 0: Normal mode (no PS print server unit) (value at time of factory
values shipment)
1: Not used
2: Not used
3: PS print server unit
4: Not used
5: Not used

[tinnyjay]

After those clears, you need to tell the copier that it has a C1 attached. Copier>Options>Int-Face> set it to 3.

IMG-CONT
Used to set connection to PS print server unit.
Setting 0: Normal mode (no PS print server unit) (value at time of factory
values shipment)
1: Not used
2: Not used
3: PS print server unit
4: Not used
5: Not used

Thank u,i'll try tomorrow,but what about changing from boot C to N.
Thank u

[teckat]

u better have those P-Prints to input the DCON Settings back in/ I warned u before on this DCON clear procedure


if u want to go out and buy a MULTI-PDL PRINTER KIT A1 w/N Boot Rom.

Resolution Switching Board A1 and Color Universal Send Kit A1P are required to give the imageRUNNER C3200 Universal Send functionality.