If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I need to test and clean the HP rotary sensor on a IR c3100. Can someone explain where is this located exactly or does anyone have a parts diagram for this machine Thanks
If you were looking from the front of copier, it would be in the 7 o'clock position of the rotary. It is on the rear wall, facing the rotary. Down near the connectors for the ATR sensor from what I can see in the book. PS24
"Once a King, always a King, but once a Knight is enough!"
Comment