[Error Code] IR 5570 have code E004-0104

[matjaz]

HAY


Replace the upper part of the heating unit but still doesn t work.Then I inserd other Fixing / Feeder FRAME ASSEMBLY and it function normally. Does anyone know what the problem is?




thx

[charm5496]

one fix has been the SW7 the Fixing Feeding Unit Detection Switch-FG6-5483-000

[Canuck]

Look inside the connectors on the fixing/feeder drawer at the rear and inside the machine for small pieces of paper

[Joesaima7749]

E004 The IH power supply is faulty/the IH control mechanism is faulty.
After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
0104 There is an IH over-current.
- Check the connector for any fault in connection.
- Replace the fixing heater power supply. (IH power supply PCB)
- Replace the DC controller PCB.

[julka123]

Replace the fixing heater power supply and fixing heater.

[Canuck]

Replace the fixing heater power supply and fixing heater.

He swapped the drawer and its working now. IH POWER SUPPLY OK. He replaced the upper fuser assembly before replacing the drawer and IT DIDNT FIX IT. Nothing wrong with these parts

[Canuck]

Make sure it has new style thermistors installed and INSPECT CONNECTORS CLOSELY.

[tongee]

E004 The IH power supply is faulty/the IH control mechanism is faulty.
After correcting the fault, be sure to reset the error. (COPIER>FUNCTION>CLEAR>ERR)
0104 There is an IH over-current.
- Check the connector for any fault in connection.
- Replace the fixing heater power supply. (IH power supply PCB)
- Replace the DC controller PCB.

it work""""

[gensys]

iR 5570 Error code E000020-000

DSC00024.JPGDSC00023.JPG

Why?
Upper Fuser Ruller not in bad condition

[Irish]

iR 5570 Error code E000020-000

[ATTACH=CONFIG]8101[/ATTACH][ATTACH=CONFIG]8102[/ATTACH]

Why?
Upper Fuser Ruller not in bad condition

E00020 is toner supply related .. Why do u think its a fuser problem?

[gensys]

There is an IH over-current.
Remedy
Check the connector for any fault in connection.
Replace the fixing heater power supply.
Replace the DC controller PCB.

[toantam]

Dear friend!
First, I think you have to check the connector behide the unit 1
Second: try to change upper Ass'y
Replace the fixing heater power supply ( Fan)

[gensys]

Thanks!!!!
Dear friend!

[bismillah]

in one side of sleeve film has a point that answer to the sensore when running
check if the sleev film will running properly and the pointer is clean or not defective