Canon np 6130 with error E000

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • gamalmehdar
    Technician

    50+ Posts
    • Mar 2008
    • 55
    #1

    Canon np 6130 with error E000

    i have this machine Canon np 6130 . it show error E000?
    how can reset this error and how can iter to the service mode. becouse i press the switch in the rear left site and the jaming ,erroe,LED flashing
    best egards
    Tags: 130, act, canon, e000, error, left, mode, reset, service, switch, th1
    • waffu22
      Technician

      50+ Posts
      • Jun 2009
      • 95
      #2
      Originally posted by gamalmehdar
      i have this machine Canon np 6130 . it show error E000?
      how can reset this error and how can iter to the service mode. becouse i press the switch in the rear left site and the jaming ,erroe,LED flashing
      best egards
      resiting in canon np 6130
      *4* , press the arrow assign until you reach the word "ERROR" and press again *

        Comment

        • teckat
          Field Supervisor

          Site Contributor
          10,000+ Posts
          • Jan 2010
          • 16083
          #3
          need to get out of the Analog World !

          Before clearing code> remove & check FUSER UNIT
          •Thermistor (TH1; off contact,poor contact, open circuit)
          •Heater (H1, H2; open circuit)
          •Thermal switch (TS1; open circuit)
          •SSR (faulty)
          •DC controller PCB (faulty)
          **Knowledge is time consuming, exhausting and costly for a trained Tech.**

            Comment

            • zoraldinho
              teacher-guide-expert-guru

              Site Contributor
              5,000+ Posts
              • Mar 2008
              • 5007
              #4
              Originally posted by teckat
              need to get out of the Analog World !

              Before clearing code> remove & check FUSER UNIT
              •Thermistor (TH1; off contact,poor contact, open circuit)
              •Heater (H1, H2; open circuit)
              •Thermal switch (TS1; open circuit)
              •SSR (faulty)
              •DC controller PCB (faulty)

              need to get out of the Analog World !

              images18.jpg
              If it ain't broke, don't fix it
              A picture is worth a thousand words

                Comment

                • gamalmehdar
                  Technician

                  50+ Posts
                  • Mar 2008
                  • 55
                  #5
                  Thanks for all.
                  i will try this when i visit my machine

                    Comment

                    Previous template Next
                    Working...