Hi everyone!
I need a little help.
At opne of my client, we changed developer cilinder and blade because one part of the page was a little bit bad, lower density. so to be sure of the quality of the image I also clean the laser unit. After replacing everything back, there was no image just blank pages.
I looked after the switches and the cables but no unplugged , didn't unplugged anything what shouldn't have been unplugged. so don't know what could be the problem.
The laser unit and the developer were tested and work fine in another machine.
Any idea?
Thank you in advance!!!!
I need a little help.
At opne of my client, we changed developer cilinder and blade because one part of the page was a little bit bad, lower density. so to be sure of the quality of the image I also clean the laser unit. After replacing everything back, there was no image just blank pages.
I looked after the switches and the cables but no unplugged , didn't unplugged anything what shouldn't have been unplugged. so don't know what could be the problem.
The laser unit and the developer were tested and work fine in another machine.
Any idea?
Thank you in advance!!!!
Comment