Hi ,
The device turning on then comes the message "PLEASE WAIT", Mainmotor turning on then stops end in this position freeze up at all!!!There no initialization on ready position!
So, I have schematic and saw where which voltages are needed, but I have no idea how to check the harness and the main board assembly!
I had have dissasemled the device and turnned on and on the wiring for the main board I have 3.3 volts and there is no 24V; and 5V. Does this voltages are needed before initialization on it!!!!?
Please somebody help whit some idea!!!
Thank`s in advance!!!
The device turning on then comes the message "PLEASE WAIT", Mainmotor turning on then stops end in this position freeze up at all!!!There no initialization on ready position!
So, I have schematic and saw where which voltages are needed, but I have no idea how to check the harness and the main board assembly!
I had have dissasemled the device and turnned on and on the wiring for the main board I have 3.3 volts and there is no 24V; and 5V. Does this voltages are needed before initialization on it!!!!?
Please somebody help whit some idea!!!
Thank`s in advance!!!