500 results in 0.0993 seconds.
-
C-450i accordian jam at fuser entrance , J-3003 code
This C450i jam at fuser rollers (not turning), no errors message or indication prior to problem. It worked until midday then started showing J-3003 codes... -
Versalink B405 dc330 doesn't turn on main motor
The customer complain for a noisy printer. It is just laboring harder then usual with 150K prints.
I run successfully the fan - no noise.... -
4002i: C2840
We looked at a Copystar CS-4002i that has a C2840 error code. We had not looked at the machine before. No idea on service history.
It didn't... -
Bizhub C227 Squealing on Duplex
Hey there,
I am a rather new technician for Konica Minolta and I am working on a c227 that is squealing really badly right when the paper is sucked... -
Belt transfer motor error C-2228
Good morning everyone, I have this machine that presents this error, I already changed the ADU drive board and Motor belt, and nothing solved it, it was... -
Part Number Help MX-B402SC Toner motor
Hey troops...
I need an assist. I've got an MX-B402SC that I need to replace the Toner Supply Motor, but the Sharp parts guide reads like... -
Kyocera 3252ci - belt cleaning motor and gears
Is there a parts break down for the DR-8350 (302L793120) drive assy. for the 3252ci. The belt cleaning motor and the 40/21 gear that it drives has some... -
e330AC Doc Feeder
In the attached picture, the two black plastic arms in the blue feed roller section are stuck in the vertical position.
I removed the blue... -
HP T2600 1009-0001-0001
I have an HP T2600 that throws a 1009-0001-0001 error when booting up or trying to scan. Service manual says to block the sensors in scanner to turn on... -
E0007-0001 Fixing Belt full displacement on imagePRESS C65
Having an issue with a C65 (same family as IR Advance 700) giving e07-01 codes. The upper fixing belt has been replaced twice, the Situation/Parts Replacement/Adjust... -
Riso RZ370EP Master Making Problems
Hello...
Need your suggestions and ideas. I m working on a Riso RZ 370 EP, it nicely starts master making process, pushes master through... -
Hp 1102 main motor problem
Hello, i have hp 1102 which prints at start normally and after little prints gears is run faster and paper not picked up. When i turn it off for a while -
MPC4503 noise
Hi,
Custommer called for noise when loading paper in cassette 2
lift motor is working, but at the end it gives a noise as if gears... -
D125 error 10 330
Hello all
Today we have a fuser motor failure 10 330 but the motor runs fine
all the rollers, gears and bearings are fine
since we... -
7002i with an intermittent C-7130
Never had this code one of these before. We swapped the developer hoping it was something in that but that isn't it. I don't think it is a motor issue...
