If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Machine shows universal send in configuration but the tab is missing. Also shows installed in service mode. Initialized data settings and still no send. What am I missing?
Could it be on the 2nd page? - had same thing on a different machine but when I went to the 2nd page (normally where MEAP is, there it was. Since they had Unv Send I removed, SCAN and SEND then appeared on 1st page.
Comment