i have an IR3320i which is scanning and faxing at 600 x 600 dpi how do it get the machine to remember a lower dpi like 200 x 200 and set it as default.....very slow at faxing so i believe this is my problem ?
-
-
Low resolution is recommended for sending documents containing text only.
Is ECM TX or ECM RX active for sending by fax in the TX Settings/RX Settings (Fax Settings) in Communication Settings?
Error Correction Mode
Press (Additional Functions) [Communications
Settings].
Press [TX Settings] under <Fax Settings> -> press [ECM TX].
When you want to communicate using ECM, it is necessary that the ECM function be set in both the other party’s machine and this machine. (Unless ECM is set in both machines,
this function will not operate.)
Before scanning, you can specify the resolution of the document to be sent.
IMPORTANT
To send jobs by fax, a resolution of 200 x 100 dpi, 200 x 200 dpi, 200 x 400 dpi, or 400
x 400 dpi is recommended. If you select a resolution other than these, it may cause
deterioration of image quality when you send the documents.
NOTE
The default setting for the resolution is ‘200 x 200 dpi (Fine)’.
DPI.JPG
Press the Resolution drop-down list -> select a resolution ->
press [OK].
The specified mode is set, and the display returns to the Fax Basic Features
screen**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment