We have a new print head and firmware.
It prints posters really well BUT
Doing a Large logo on a banner 42"x96" 300 DPI
on vinyl the black large lettering starts out dense and solid but 1/2 way thru starts to just run out of ink only black.
like it just fade off with feathering past the letter itself
the other colors are fine but all new ink and many cleaning cycles
starts out just fine then as if its running out of ink
Ink is fresh.
It did this the same when we reprinted it again.
Big black lettering and it seems just run out, keeps printing the boarder on the lettering fine.
The level height adjustment on the side where the head assy was in the middle setting and I even moved the to the low , nada.
The print head will print small text ok.
ALSO when I do Print head Adj I get a E2820 ADJ Failed
Any help guys?
We did change the ink mbk and PK.
it just seems not to be able to refresh the ink on the solid BK print of large letters.
Is there a adjustment I am missing
the cleaning cycle shows a lot of ink in the waste tray of the bK
It prints posters really well BUT
Doing a Large logo on a banner 42"x96" 300 DPI
on vinyl the black large lettering starts out dense and solid but 1/2 way thru starts to just run out of ink only black.
like it just fade off with feathering past the letter itself
the other colors are fine but all new ink and many cleaning cycles
starts out just fine then as if its running out of ink
Ink is fresh.
It did this the same when we reprinted it again.
Big black lettering and it seems just run out, keeps printing the boarder on the lettering fine.
The level height adjustment on the side where the head assy was in the middle setting and I even moved the to the low , nada.
The print head will print small text ok.
ALSO when I do Print head Adj I get a E2820 ADJ Failed
Any help guys?
We did change the ink mbk and PK.
it just seems not to be able to refresh the ink on the solid BK print of large letters.
Is there a adjustment I am missing
the cleaning cycle shows a lot of ink in the waste tray of the bK