canon IR2500 series

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • George_H
    • Jun 2025

    #1

    canon IR2500 series

    Can we easily replace the main board of Canon IR2525 by the main baord of IR2535, to let Canon IR2525 copy on 35 ppm????
  • teckat
    Field Supervisor

    Site Contributor
    10,000+ Posts
    • Jan 2010
    • 16083

    #2
    Originally posted by George_H
    Can we easily replace the main board of Canon IR2525 by the main baord of IR2535, to let Canon IR2525 copy on 35 ppm????
    this is not a Forum for stupid questions
    Main Drives are different/ Fuser Units are different/etc.
    NO.jpg
    **Knowledge is time consuming, exhausting and costly for a trained Tech.**

    Comment

    • George_H

      #3
      Sorry Dear, i meant IR 2535 and IR 2545

      Comment

      • BluePatriot

        #4
        The controller board is the same for the 35/45 machines. It will not turn a 35ppm into a 45ppm.

        Comment

        • George_H

          #5
          Ok, is there any way to let the 2535 copy at 45 ppm since both machines have same engine and design?????

          Comment

          • teckat
            Field Supervisor

            Site Contributor
            10,000+ Posts
            • Jan 2010
            • 16083

            #6
            Originally posted by George_H
            Ok, is there any way to let the 2535 copy at 45 ppm since both machines have same engine and design?????



            please get a life/your deception is not approved
            **Knowledge is time consuming, exhausting and costly for a trained Tech.**

            Comment

            • JustManuals
              Field Supervisor

              5,000+ Posts
              • Jan 2006
              • 9838

              #7
              Another moron who just can't take no for an answer.

              Comment

              • Tricky
                Field Supervisor

                Site Contributor
                2,500+ Posts
                • Apr 2009
                • 2620

                #8

                Comment

                Working...