[Misc] Touch panel mismaching

[bineshpaul]

Dear Friends,

In my IR6570 machine the touch panel is not working properly. it miss match the position when i touch the Deck 1 A4 button it select the Deck 2 A4 buttion. like this all the buttions are mis maching due to this i can't use the service mode and select the other options. pls help me to find out the solution.


Regards
Binesh

[teckat]

SERVICE MODE>COPIER >FUNCTION>PANEL>TOUCHCHK

Use it to adjust the coordinates of the analog touch panel.
Procedure
- Use it to match a specific point of the touch panel and its
coordinates on the LCD.
- If you have replaced the LCD assembly, be sure to execute this
service mode item.
1) Select [TOUCH CHECK] to highlight, and press the OK key.
2) Press the 9 + symbols that appear on the touch panel to make adjustments.

Touching the cross-hair on the screen will calibrate the LCD, there are 9 points on the screen reset out after completion and power cycle the machine. If the adjustment cannot be performed replace the assembly.

[bineshpaul]

Dear,

i cannot select function due to mismaching . How to remove the touch panel assembly.

Regards
Binesh

[teckat]

Removing the Control Panel
-1) Open the hopper front cover
-2) Remove the 5 screws [1].
CP.JPGtwo screws
CP2.JPGtwo screws
CP3.JPGone screw
CP4.JPG

[mr.daus]

replace the touch screen,,,,, but be carefull for replace it

[universaltvm]

hi binesh man wer r u frm kerala